Digital ID View 960H Series Manual de Instruções descarregar pdf (Página 41)

4.2.3. Sensor

 ON/OFF

Turn on or turn off the sensor

 CAMERA

Select the associated camera

 OUT

Select the associated alarm output

Caution

Relay contact can handle up to 24V/1A of other devices. If connected to a circuit which is

Over 24V/1A, the system may experience problems.

 INTENSIVE

“Intensive” means that the system increases recording speed up to the maximum frame rate at the selected

resolution when an alarm is triggered during the selected dwell time. The recording speed of all other channel

will be automatically decreased during alarm-triggered intensive recording. The unit will also trigger an alarm

signal via the selected sensor-out channel.

 PRESET

User can select the camera to move to a preset position, once the sensor is triggered. (User should setup preset

position in PTZ menu 4.2.6 in advance)

 DWELL (Post Alarm)

Set the recording period from the start of sensor input activation. During this period, the corresponding camera

video will record according to the frame and alarm (relay) output set. The recording stops and alarm output is

turned off when the dwell time has elapsed.

 PRE-ALARM

Set the recording period in seconds just before the alarm-sensor input, up to 3 seconds.

The system records video for the defined amount of pre-alarm so that user can search video even before alarm

is triggered. The pre-alarm recording mode is at the recording that user sets in “record” of “camera” menu.

 TYPE

Select the sensor type between N/O(Normal Open) and N/C(Normal Close), connected to the alarm input

terminal. A circuit of N/O type activates the sensor when the circuit closes. An N/C circuit works in the reverse

way.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 64 65

Sem comentários

Digital ID View 960H Series Manual de Instruções Página 41