Digital ID View 960H Series Manual de Instruções descarregar pdf (Página 44)

4.2.6. PTZ

Full control of PTZ camera is available in this menu.

For details, please refer to Section 3.3 PTZ Operation.

“M” (Depending on the model of PTZ camera)

If selected, the OSD menu of PTZ camera is imported and shown on the DVR monitor allowing the user to control the full

PTZ settings.

Protocol

Select the proper protocol of the connected PTZ camera.

Address

Set the PTZ driver address of the connected camera.

Check the below items for proper P/T/Z operation.

1. Check if the protocol of the connected PTZ camera is correct.

2. Check if the communication setting including baud rate of the connected PTZ camera is in accordance with the assigned

value for that P/T/Z protocol.

3. Check if the address of the connected PTZ camera is correct.

4. Check if wiring to P/T/Z controllers is correct.

Procedure How to setup PTZ camera with Pelco-D protocol (example)

1) Make sure the serial communication with the PTZ camera is through RS-484 port.

2) Select “Pelco-D” at the protocol list, and set the address.

3) Select Baud Rate to be the same as the PTZ camera

4) Click the “Save” button to confirm this configuration.

Preset

The system supports the number of preset from 1 to 255.

Baud Rate

User can select the baud rate level from 2,400bps up to 57,600bps.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 64 65

Sem comentários

Digital ID View 960H Series Manual de Instruções Página 44